Deejay Pre II - Preamplifier for turntables

The DJ PRE II is a high quality phono preamp designed for home and studio use.
It acts as an interface between your turntable and your audio recording system.
The analog input capacity can be switched between 100pF and 200pF to optimize the response of the phono cartridge.
A switchable low-cut filter removes rumble, leaving the audio intact.
Front Gain Trim control and Signal / Clip LED allow you to optimize the preamp gain for a wide range of input sources.
The built-in low-noise phono preamp circuitry is very accurate and strictly compliant with the RIAA standard.
The line out sockets are low impedance and can work with any sound card. Housed in a black anodized all-aluminum case, the DJ PRE II can be powered via a variety of external power supplies.

Frequency response: 10Hz- 50kHz, ± 0.5dB
THD (Total Harmonic Distortion): .01% typical @ 1kHz
Hum and Noise (Signal / Noise):> 90dB below clipping
Input impedance: 47 kOhm in parallel at 100pF and at 200pF
Maximum input level: 40mVrms @ 1kHz
Maximum gain: 45dB @ 1kHz
Input / Output Connections: RCA
MM type input
Maximum output level: + 6dBu (1.4Vrms)
Filter Type / Response: Switchable, Hi-Pass, -3dB @ 22Hz
Power requirements: 7-12V DC or 9-12V AC @ 150mA
Dimensions: 47 x 117 x 114mm
Weight: 0.57 kg
Power supply included