PSM®200 System

RF Output Power: 10 - 30 mW (countryspecific)
Operating Distance: Up to 100 mm
Harmonic distortion: 1.5 % typical
Signal-to-noise-ratio: 80 dB (A) typical
Listening mode: Mono
Compatible Systems per band (up to): 4
Transmitter Inputs: 2x XLR/6,3 mm combo, mic/line level
Transmitter Outputs: 2x XLR split outputs
Wired Bodypack Option: Yes
Personal Mix Control: On transmitter
Remoteable Transmitter: No
Battery Life: Wired: 6 h; Wireless: 4 h
Frequency Response: 30 Hz - 12 kHz

Further technical specifications:

PSM®200 System

RF Carrier Frequency Range: 518­-865 MHz (country dependent)
Modulation: FM +/- 35 kHz Deviation (Nominal)
Operating Temperature: -7 degrees C to +49 degrees C (+20 degrees F to +120 degrees F)

EP2T TransMixer

Modulation Limiter: Internal peak limiter (>10:1 hard knee compression)
Antenna: 1/4 Wavelength, semi-rigid, PCB Mount
Connector Type: XLR/1/4-inch combo
Nominal Input Level: 25 dBu @ 1/2 volume (12 o'clock)
Maximum Input Level: 5 dBu @ 1/2 volume (12 o'clock)
Current: 170 mA maximum
Dimensions: 220 mm x 140 mm x 40 mm (8.6 in. x 5.6 in. x 1.7 in.)
Net Weight: 370 g (13 oz.)

P2R Receiver

RF Sensitivity: 109 dBm typical
Squelch Threshold: 102 dBm typical
Antenna: Attached Whip
Audio Input Connector: Connector Type: 1/4-inch Mono
Impedance: 1 megohm
Maximum Input Level: LO = +0 dBu; HI = 10 dBu
Frequency Response: 30 Hz to 20 kHz (+/ 3 dB); earphone dependent
Power Requirements: 9 V alkaline battery, Duracell® type MN1604 recommended
Audio Output Connector: 1/8 inch (3.5 mm)
Minimum Load Impedance: 8 ohms
Net Weight: 100 g (3.52 oz.), less battery
Overall Dimensions: 122 mm x 73 mm x 32 mm (4.809 in. x 2.875 in. x 1.251 in.)

SE215 Earphones

Frequency Range: 22Hz – 17.5kHz
Sensitivity: 107 dB SPL/mW (@ 1kHz)
Impedance: 20 Ohms (@ 1kHz)
Input Connector: 3.5mm (1/8”)
Colour: Clear